Eagle 320 Uživatelský manuál Strana 12

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 36
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 11
Page 10 of 32P/N 595176-01 Rev. C 1/11
BATTERY CHARGING
Power for the EAGLE IMAGER 320 Thermal Camera is provided by a single
Nickel-Metal Hydride (Ni-MH) Battery. The battery must be fully charged
before placing the camera in service. CONSULT APPLICABLE REGULA-
TIONS REGARDING DISPOSAL OF RECHARGEABLE NI-MH BATTERIES.
The Battery Charger base may be powered by either the 12 VDC adapter
power supply or the 100-240 VAC power supply (the appropriate line cord
and plug are required).
1. Plug the battery charger pow-
er supply into a suitable power
source:
a) Local line voltage for the 100-
240 VAC power supply or
b) 12 VDC vehicle outlet (ciga-
rette lighter) for the 12 VDC
adapter power supply.
2. Plug the charger power supply
cord into the charger base. See
FIGURE 2. When the charger is
connected to power, both lights on
FIGURE 2
the charger base will light rst GREEN, then RED, and then go out.
3. Identify the location of the contacts on the bottom of the battery. Verify that
they are clean and not damaged. See FIGURE 3.
FIGURE 4
ALIGN
FLATS
FIGURE 3
BATTERY
CONTACTS
WARNING
BATTERY CAN EXPLODE, LEAK, OR CATCH ON FIRE IF DIRECTLY
EXPOSED TO HIGH TEMPERATURE, WATER, OR FIRE, OF IF
OPENED, DISASSEMBLED, OR TAMPERED WITH. DO NOT PUT WIRE,
METAL, OR OTHER CONDUCTIVE MATERIAL ACROSS THE TERMINALS,
DO NOT IMMERSE THE BATTERY. FAILURE TO HANDLE BATTERY
PROPERLY MAY RESULT IN SERIOUS INJURY.
EXTERNAL CONTACTS
ON THIS SIDE
Zobrazit stránku 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Komentáře k této Příručce

Žádné komentáře