Eagle 320 Uživatelský manuál stáhnout pdf (Strana 5)

Page 3 of 32 P/N 595176-01 Rev. C 1/11

INTRODUCTION CONTINUED

ON NEXT PAGE...

– The OVERHAUL (Green/Orange) mode displays the range of relative

temperatures in the screen as color from shades of GREEN for cooler

objects to shades of ORANGE for warmer objects. Rather than displaying

colors that correspond to an actual value, this mode looks at the entire

scene in the display, calculates the range of temperatures, and determines

the middle of the range. This feature may be an aid in helping re ghters

direct operations.

In addition to the three display modes, the EAGLE IMAGER 320 Thermal

Camera display has two settings of digital ZOOM, two times (2 X) and four

times (4 X), to enlarge the center region of the display. The ZOOM features

works the same in all three display modes.

The power controls consist of two glove accessible buttons that perform a va-

riety of functions. LED’s in the two buttons light on initial start-up. The display

provides information including mode selection, battery status, and analog and

digital temperature indicators which give the approximate temperature of the

target region at the center of the display in degrees Fahrenheit (Celsius is avail-

able as a factory installed option). A MAX Temp™ readout shows the highest

temperature in the display. There is also an over temperature warning to warn

when the core of the camera has exceeded a safe operating temperature.

When the camera is powered up, it will begin operating in whatever display mode

was active when the camera was properly shut down. The optional transmitter

will also return to its last active state. However, the ZOOM will always return

to 1X display at start up.

The nickel-metal hydride (Ni-MH) battery is capable of powering the unit ap-

proximately 4 hours (approximately 2½ hours with the transmitter in use). A

battery power gauge appearing in the display is standard.

The three-position handle adjusts to accommodate various angles of view.

Hand straps are tted to both sides of the camera housing. Replaceable rub-

ber bumpers protect the camera housing and the battery area of the handle.

The lens is covered by a replaceable high impact cover that is chemical, water,

and heat resistant.

Use and maintenance of this instrument must be part of a complete thermal

imaging camera training program. The following procedures shall be used to

operate and maintain the unit prepared for emergency use. The unit shall be

inspected after each use. There are no user serviceable parts inside the cam-

era except as outlined in this instruction. If any malfunction is noted, remove

the unit from service and return to SCOTT Health & Safety authorized service

center for repair.

The EAGLE IMAGER 320 Thermal Camera is not a night vision camera.

Although this device can signicantly enhance vision in certain situations, the

user must never become wholly dependent on the unit for personal naviga-

tion. Always maintain awareness of location and escape routes when using

this device.

1 2 3 4 5 6 7 8 9 10 ... 35 36

Komentáře k této Příručce

Žádné komentáře

Eagle 320 Uživatelský manuál Strana 5

Komentáře k této Příručce