Eagle 320 Uživatelský manuál Strana 13

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 36
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 12
Page 11 of 32 P/N 595176-01 Rev. C 1/11
4. The battery has ats on two sides
to align with the matching ats
in the battery charger. Position
the battery as shown in FIGURE
4 with the ats aligned and the
three (3) external contacts to the
left side of the charger base. See
FIGURE 4. The light on the right
will light RED while the battery is
charging. See FIGURE 5. If the
light does not go on, check the
orientation of the battery.
5. When the battery is fully charged,
FIGURE 5
the light will change to GREEN. Battery will require approximately hours
charging prior to initial use. After each use of camera, battery should be
recharged until the light turns GREEN.
6. Batteries shall be recharged on a regular basis once a week to maintain a
full charge ready for use.
7. If the light in the charger base glows YELLOW, it indicates that the bat-
tery is outside the temperature range for charging.
a) Heavy use of the camera will generate heat in the battery. Allow the
battery to cool before charging.
b) Storing a battery in cold temperatures will prevent charging. Move the
battery to a warmer environment before charging.
A battery may be left in the charger until it cools or warms into the
charging temperature range, at which point the light will change from
YELLOW to RED and the battery will begin the normal charging cycle
as described above.
8. If the light on the charger base FLASHES RED as soon as a battery is
placed in the charger, it indicates a defect in the battery. If a battery is in
the charger for more than 4 hours and the light has not changed from RED
to GREEN, the light will begin to FLASH RED, also indicating a defect in
the battery. Remove the battery from service and dispose of according
to applicable regulations. See the BATTERY DISPOSAL section of this
instruction.
CHARGING
LIGHT
CAUTION
NOT ALL POWER SOURCES ON VEHICLES ARE ACTIVE ALL THE
TIME. BE SURE THAT THE POWER SOURCE CHOSEN WILL PROVIDE
THE NECESSARY POWER FOR THE TIME REQUIRED TO CHARGE A
BATTERY. THE 12 VDC ADAPTER WILL NOT CHARGE A BATTERY
IF THE POWER SOURCE TO THE 12 VDC ADAPTER IS NOT ACTIVE.
CONSULT THE BUILDER OF YOUR VEHICLE IF YOU HAVE ANY
QUESTIONS ABOUT ITS AVAILABLE POWER SOURCES BEFORE
USING THE 12 VDC ADAPTER.
EXTERNAL
CONTACTS ON
THIS SIDE
Zobrazit stránku 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Komentáře k této Příručce

Žádné komentáře