Eagle 320 Uživatelský manuál stáhnout pdf (Strana 34)

Page 32 of 32P/N 595176-01 Rev. C 1/11

LENS ASSEMBLY REPLACEMENT

If the Lens Assembly becomes damaged, it can be replaced with replacement

Lens Assembly P/N 40014748. This replacement must be performed in a clean

and dry (low humidity) work area. Clean the EAGLE IMAGER 320 Thermal

Camera according to the MAINTENANCE section of this instruction. Replace

the Lens Assembly as follows:

1. Unscrew the old Lens Assembly

counter clockwise as shown in

FIGURE 26 and discard.

CAUTION

PERFORM THIS OPERATION ONLY IN A CLEAN, DRY (LOW HUMIDITY)

WORK AREA. WHILE THE LENS IS OFF, DO NOT TOUCH THE SHUTTER

ASSEMBLY OR THE INTERNAL LENS. DO NOT PERMIT ANY MOISTURE,

DIRT, OR FOREIGN MATERIAL INTO THE SHUTTER/LENS AREA. DIRT,

MOISTURE, OR DAMAGE IN THIS AREA MAY AFFECT THE OPERATION

OF THE CAMERA.

FIGURE 26

FIGURE 27

CHECK

O-RING

2. The replacement Lens Assembly

comes with a new O-Ring installed

and lubricated ready for installa-

tion. Check to make sure O-Ring is

not damaged. See FIGURE 27.

3. Carefully thread the new Lens

Assembly clockwise into the front

of the camera until fully seated

against the O-Ring. Snug down

by hand. Do not use any tool to

tighten.

CAUTION

DO NOT USE TOOLS TO TIGHTEN THE REPLACEMENT LENS ASSEM-

BLY. USE OF TOOLS MAY DAMAGE THE LENS OR THE SEAL WHICH

COULD LEAD TO FAILURE OF THE CAMERA.

1 2 ... 29 30 31 32 33 34 35 36

Žádné komentáře

Eagle 320 Uživatelský manuál Strana 34